This article describes how to replace the motor driver on axis 5 of the Horst 1000.
|
|
DANGER! Danger resulting from incorrect commissioning ⇒ Commissioning must be performed only by persons with technical and electrotechnical training who were also authorized by fruitcore robotics! |
Spare parts required:
|
Driver unit A5 |
PP001413 |
- Shut down the robot and disconnect it from the power grid.
-
Loosen the marked countersunk screws.
- Remove the plug connections underneath and remove the motor driver.
- Connect the new motor driver and screw it in place.
- Attach the bus cables and check the software status to verify that the replacement was successful and the robot is working properly.
